BodyGuard
SAFETY SOLUTIONS
-Tag
®
Driver Awareness System
BodyGuard Safety Solutions—A division of Orbit Communications Pty Ltd Install Guide rev r1.11
Page
16
Alert Speaker Volume
The volume of the speaker has 16 levels of adjustment from softest to loudest setting. The
adjustment is made by changing setting on the rotary switch inside the Cab Unit. Access to the Cab
unit is achieved by pulling up the plastic side covers from the lid by hand to reveal the 4 fastening
bolts. Undo the 4 bolts to remove the lid.
The lid is connected to the base of the Cab Alert unit by
thin cable, be careful not to stretch the cable when removing the lid.
The minimum setting is “0”. Increase volume by moving switch CLOCKWISE (maximum setting is “F”)
and software by turning anti-clockwise. The alert will sound each time the switch is changed, this
provides an indication of the new volume setting.
Configuration software
Refer to configuration and log management device “User guide”.
System Operation
Power Up
At power up the system will flash warning LEDs, turn on “POWER LED” and provide system start up
voice notifications.
Communication with each fitted sensor is checked and voice notification given.
Example;
“Front Tag Sensor OK”, “Rear Tag Sensor OK” (for dual system)
“Tag Sensor OK” for single sensor system (single system)
“No Front Sensor Found” or “No Rear Sensor Found” (dual system)
“No Sensors Found” (single system)
Once the system has started without error, the Cab alert unit will begin communication with the
sensor units. Valid responses from the sensor units cause the “Detect” LED on the front panel to blink.
During normal operation, “Detect” LED should be blinking non-stop.
Power Down
If the Ignition Sense is used, the Power Led will remain ON after vehicle ignition switches off. The
system can connect to handheld configuration and log device management in this mode. When
ignition is switch back on, the system will power up and start detection.
0
F
1
2
E
