BodyGuard
SAFETY SOLUTIONS
-Tag
®
Driver Awareness System
BodyGuard Safety Solutions—A division of Orbit Communications Pty Ltd Install Guide rev r1.11
Page
15
Detection Zone distance setting
The range of the detection is set using the 4-way switch inside the sensor unit. (Note: The Lid is
connected to the base by cable, be careful not to stretch cable).The values shown below are
approximate distance settings. The table below provides a guideline for initial zone range setting. Test
the system by walking in and out of zone with Tag and then adjust range up or down as required until
desired range achieved. (
Do NOT open lid when water can enter and ensure lid fastened securely after
distance adjusted
).
Distance
Switch 1
Switch 2
Switch 3 Switch 4
3
OFF
OFF
OFF
OFF
4.5
ON
OFF
OFF
OFF
5.5
OFF
ON
OFF
OFF
6.5
ON
ON
OFF
OFF
7
OFF
OFF
ON
OFF
7.5
ON
OFF
ON
OFF
8
OFF
ON
ON
OFF
8.5
ON
ON
ON
OFF
Maximum
ON
ON
ON
ON
Sensor ID
The sensor can be assigned an ID from “0” to “15” (Characters “A” through “F” represent values “10”
through “15”) using the rotating selection switch inside the Sensor unit. This switch sets the location
of the sensor on the vehicle.
Single system Sensors and dual “Front” Sensors; set ID = “0”.
Dual system “Rear” Sensors; set ID = “1”.
NOTE: Single system MUST have Sensor ID set to “0”.
ON
1
2
3
4
Range Setting Switch (LEFT =
OFF
, RIGHT =
ON
)
0
F
1
2
Front
Rear
E
