W2
W3
W1
W4
W5
W6
144
147
101
213A
5
W1
144
147
5
101
W2
W3
101
170
134
25
C5
W4,W5,W6
245
212
213A
202
W4
W5
W6
Leg Press Low Cable (213A)
Ball End
Threaded End
1. Remove the Low Cable (87) of Elite. If you have installed the
Low Cable (87), you must remove it now. This cable will be
replaced by the Leg Press Low Cable (213A).
2. Insert the Threaded End of Leg Press Low Cable (213A) into
the front of the Foot Plate Connector (5), and route underneath
pulleys W1 and W2, each mounted using 3/8" X 45L Flat Pin
Bolt (144) and M6 X 12L Male Screw (147), as shown in
W1&W2.
3. Continue routing up and around pulley W3, mounted to the
bottom of the Double Pulley Block (25), using 3/8" X 1-3/4”
Hex Bolt (134) and 3/8” Nylon Nut (170) as shown in W3.
4. Route underneath pulley W4 mounted on Connecting Rear
Stabilizer (202), using a 3/8" X 1-1/2" Hex Bolt (245). Continue
routing the cable around horizontal pulley W5 mounted on
Sliding Pulley Block (207) using 3/8” X 1-3/4” Hex Bolt (231)
and 3/8” Nylon Nut (237), then screw the Thread Bolt End of
Leg Press Low Cable (213A) into the Connecting Rear
Stabilizer (202) as shown in Fig. W4, W5, W6.
STEP 2 INSTALL LEG PRESS LOW CABLE
5
