Page 7
Hardware & Tool Required
Bolts
Washers
Others
#52. Screw (M4x12xφ6 mm)
[2 Pieces]
#51. Washer (d4xφ12x1 mm)
[2 Pieces]
#11. Knob Bolt (M16x1.5x15xφ49 mm)
[2 Pieces]
The assembly process is now complete However,
for your own safety, please make sure to read this
entire manual which includes safety instructions and
warnings as well as any safety/warning labels located
on the product before use.
Do not remove the
Seat (#15)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#15)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
W A R N I N G
Spring Knob Operation
Turn
Knob Bolt (#11)
counter-clockwise
three times.
Pull
Knob Bolt (#11)
outward and adjust
Seat Post (#17)
simultaneously.
Push
Knob Bolt (#11)
back inward until
it clicks and then tighten it by turning
clockwise.
BF 2700
Seat Post Assembly
Attach the
Horizontal Seat Bar (#14)
to the
Seat Post (#17)
with the single point of the
seat (#15)
pointing toward the
front of the unit as shown in the diagram. Secure by locking
the
Knob Bolt (#11)
.
Attach the
Seat Post (#17)
onto the mouth of the post that is
protruding from the
Main Frame (#09)
down a minimum of 4
inches to engage the lowest hole. Please ensure that the hole
on the
Seat Post (#17)
facing the same side as the
Knob
Bolt (#11)
so it can be aligned and full engage through the
lowest corresponding hole on the
Main Frame (#09)
post and
fully through (at minimum) the lowest the hole located on the
Seat Post (#17).
Please refer to the illustration.
You may adjust the
Seat (#15)
to the height most comfortable
for you after complete assembly. Please always check to
ensure a hole has been fully engaged when you secure and
tighten the
Knob Bolt (#11).
Water Bottle Holder Assembly
Remove the two
Screws (#52)
and two
Washers (#51)
that
are pre-installed on the
Main Frame (#09)
as illustrated and
set them aside.
Attach the
Water Bottle Holder (#50)
to the
Main Frame
(#09)
and secure them together by inserting two
Screws
(#52)
through two
Washers (#51)
then through the
Main
Frame (#09)
as illustrated.
The two
Knob Bolts (#11)
are pre-assembled on the
Seat
Post
(#17)
and
Main Frame (#09).
A s s e m b l y S t e p 3
55
40
1
2
3
4
55
40
1
2
3
4
STEP3:
Assembly Instructions
