User manual for BCL-B series laser machine
Jinan Bodor CNC Machine Co.,Ltd
www.bodorcnc.com
20
●Must make sure water-in gate is downside and water-out gate is upper side. Keep
the water go into laser tube from lower gate and out from upper gate. Take above picture
as reference.
●Make sure every connection of water tube is well connected in case any leakage.
Water tube should be straightened.
3.2.3 Installation of Water Chiller
▲Firstly open the water-in gate of water chiller and fill pure water or distilled
water into it fully.
▲Then connect water-in/out gate of water chiller with water out/in gate of laser
machine to make sure the water cycling path.
▲Finally, connect Signal wire and power line of water chiller.
After installation of laser tube, press button to open it. There will be sound of water flow,
water will fill inside water tube from higher-voltage end to lower-voltage end. Then green
light on water chiller flashes. It proves water cycle is normal if there is no alarm.
PS
：
●Water flows from water-in gate to water-out gate during working. Or it will hurt
laser tube.
●Power on the machine. If there is any bubble inside laser tube, we could squeeze
the water tube softly or rotate laser tube to expel the bubbles.
●During machine running, do not touch higher-voltage wire to keep safety.
Rocker switch
Display
Alarm
Light
Running
Light
Chiller
Model
