BOC Edwards A730-01-983, Инструкция по эксплуатации, Страница: 17 / 44

Nov 02 Issue A
XDS Dry Pump
INSTALLATION
PAGE
11
11
Make sure that the exhaust pipeline cannot become
blocked. If you have an exhaust isolation valve, make
sure that you cannot operate the pump with the
valve closed.
Provide for a purge of inert gas when you shut down
the pumping system, to dilute dangerous gases to
safe concentrations.
3.3 Unpack and inspect
Remove all packing materials, remove the pump
from its packing box, remove the protective covers
from the inlet and outlet ports and inspect the
pump. If the pump is damaged, notify your supplier
and the carrier in writing; state the item number of
the pump together with your order number and
your supplier's invoice number. Retain all the
packing materials for inspection. Do not use the
pump if it is damaged. If the pump is not to be used
immediately, replace the protective covers. Store
the pump in suitable conditions, as described in
Section 6.1. Refer to Section 6.2 for disposal of
materials.
3.4 Locate the pump
Provide a firm, level platform for the pump. Locate
the pump so that the gas ballast control and the on
/ off switch are accessible.
WARNING
Use suitable lifting equipment
to move the XDS35i pump.
The mass of the pump is
approximately 48 kg.
WARNING
If the pump is to be used on the floor
of a work area, position the power
lead and the exhaust and inlet hoses
with care. Ensure that personnel in
the area are aware of any
obstructions around the pump.
If your pump will be located inside an enclosure,
make sure that there is adequate ventilation at both
ends of the pump, so that the ambient temperature
around the pump does not exceed 40 ºC. There
must be a minimum space of 25 mm between the
pump and the enclosure walls.
3.5 Electrical installation
3.5.1 Check and configure the pump
Ensure that the voltage shown on the voltage
indicator (refer to Figure 1, item 8) on the motor
cover corresponds with your electrical supply
voltage. If it does not, you must change the
configuration of the pump motor to match your
supply voltage; use the procedure below.
1. Undo the two screws and lift off the voltage
indicator moulding.
2. Rotate the voltage indicator moulding so that
the correct voltage is uppermost.
3. Replace the two screws.
CAUTION
Ensure that the pump is correctly configured for
your electrical supply otherwise you may cause
damage.