BOC Edwards 18B4B, Инструкция по эксплуатации, Страница: 55 / 62

Feb 04 Issue A
18B4B Vapour Booster Pumps
PAGE
49
49
S
T
ORAG
E
AND DISP
OSAL
6 STORAGE AND
DISPOSAL
6.1 Storage
Use the procedure below to store the pump:
1. Shut down the pump as described in
Section 4.8.
2. Isolate the pump from the electrical supply.
3. Refer to Figure 1. Disconnect the inlet (1) and
outlet (16) from your vacuum system.
4. Drain the pump fluid as described in
Section 5.5.
5. Dismantle, clean and reassemble the pump as
described in Section 5.6. Do not refill the pump
with fluid.
6. Place protective covers over the inlet (1) and
outlet (16) and the cooling-water inlet (4) and
outlet (15) connectors.
7. Store the pump in cool dry conditions until it is
required for use.
When required, prepare and install the pump as
described in Section 3.
6.2 Disposal
Dispose of the pump, pump fluid and any
components removed from the pump safely in
accordance with all local and national safety and
environmental requirements.
Take particular care with the following:
• Components which have come into contact
with pump fluid.
• Fluoroelastomers which may have been
subjected to temperatures above 315
o
C (see
Section 5.1).
• Breakdown products which may be present if
the pump fluid has been subjected to
temperatures above the fluid breakdown
temperature.
• Components or used pump fluid which have
been contaminated with dangerous process
substances.