BobsCNC Evolution 4, Инструкция по сборке, Страница: 137 / 139

136
Appendix
Evolution 4 Firmware Values
Key Value Description
$0 10 (step pulse, usec)
$1 25 (step idle delay, msec)
$2 0 (step port invert mask:00000000)
$3 0 (dir port invert mask:00000000)
$4 0 (step enable invert, bool)
$5 1 (limit pins invert, bool)
$6 0 (probe pin invert, bool)
$10 1 (status report mask:00000011)
$11 0.01 (junction deviation, mm)
$12 0.002 (arc tolerance, mm)
$13 0 (report inches, bool)
$20 1 (soft limits, bool)
$21 0 (hard limits, bool)
$22 1 (homing cycle, bool)
$23 3 (homing dir invert mask:00000011)
$24 250 (homing feed, mm/min)
$25 2000 (homing seek, mm/min)
$26 250 (homing debounce, msec)
$27 5 (homing pull-off, mm)
$30
1000
Maximum spindle speed, RPM
$31
0
Minimum spindle speed, RPM
$32
0
Laser-mode enable, boolean
$100 80 (x, step/mm)
$101 80 (y, step/mm)
$102 400 (z, step/mm)