Bob’s Space Racers Inc. |
Rescue 1™ Operator’s Manual (V1.SEPT2014)
20
8.
M
AINTENANCE AND
I
NSPECTION
(C
ONTINUED
):
8.3 Changing the water:
It is highly recommended to change the water for the game every week in
order to keep the game clean. Fully read and follow the below steps in order
to properly change the water:
1.
Keep game power on, but ensure that no one plays the game until after the
water has been changed out.
2.
Open the bottom access panel located behind the game to gain access to the
water pump, water filter, and all hose connections and fittings.
3.
Place the drain tube into a large bucket.
4.
Fully open the drain tube valve by turning the drain valve handle counter-
clockwise.
5.
While securely holding the drain tube into the bucket,
press and hold
the
“CHANGE WATER BUTTON”
located above the pump plug. This will start the
pump, and water will begin to be pumped out of the game and into the
bucket.
NOTE:
The pump will only work and drain while the
“CHANGE
WATER BUTTON”
is being pressed. Once the bucket is full or all water has
been drained, release the
“CHANGE WATER BUTTON”
.
6.
Once all water is drained, fully close the drain tube valve by turning the valve
handle clockwise.
7.
If the water filter needs to be changed at this time, do so while the water is
drained. Follow the steps in
Section 8.4 “Changing the water filter”
in order
to properly change the water filter.
8.
Pour clean tap water (approximately ten gallons) into the water holding tank
from the front of the game. Do not use any form of chemical cleanser or
deionized distilled water to put into the game.
CHANGE WATER BUTTON
DRAIN TUBE VALVE:
Clockwise =
CLOSE
Counter-Clockwise -
OPEN
PUMP
DRAIN TUBE
BUCKET
