Congratulations on your
purchase of the BOB
Weather Shield. It is
designed to provide
your child with
protection from
inclement weather.
Proper installation and
care will provide years
of reliable service.
Before attempting to
use or attach your new
Weather Shield, read
and understand these
instructions
completely to insure
proper assembly and
operation.
If you are
unclear on any point,
contact your dealer or
BOB before use.
Warnings
. This product is
designed exclusively
for use with BOB
Revolution Duallie
strollers. It is not
intended for use with
other strollers or
products.
.
The Weather Shield
is made of a non-
breathable material.
To avoid danger of
suffocation and
excessive
temperatures,
follow all assembly
instructions.
. Always make sure all
vents are
unobstructed, as
indicated in Fig.1.
. The Weather Shield
is not designed to
work with optional
Infant Car Seat
Adapter and car seat.
. Do not use Weather
Shield when
temperatures exceed
65
o
F/18
o
C. Use in
higher temperatures
can cause unsafe
conditions inside the
Weather Shield.
. Never leave child
unattended.
. When not in use,
keep out of reach of
children.
INSTALLATION
INSTRUCTIONS:
1.
Set stroller Parking
Brake (refer to Parking
Brake section of stroller
Owners Manual). Place
each sun canopy into
position to receive the
Weather Shield as
shown in Fig.2.
2.
Pull each canopy
drawstring in order to
gather extra material
under canopy. Cinch
cord lock against
canopy to retract and
hold material, as shown
in Fig. 3.
Very important: when
the Weather Shield is
used, the rear canopy
flap must be in correct
position as described
below. This will insure
proper airflow and
avoid danger of
suffocation.
3.
Locate rear canopy
flap and fold forward.
Attach canopy flap
velcro on flap to
respective velcro mate
on top outboard side of
each canopy as shown
in Fig. 4). Warning tag
on rear canopy flap also
describes and illustrates
this critical step.
4.
Inspect opening at
back of stroller to make
sure the air passages
between top of seat
back and canopy are
unobstructed (see Fig.
5). We recommend
reclining each seat back
slightly to optimize
airflow (refer to
Reclining Seat section
of stroller Owners
Manual).
5.
Place Weather
Shield on the stroller so
the rear flap drapes over
back (between the
handlebars) and the
seam above the window
is aligned with the
forward Sun Canopy
supports (see Fig. 6).
6.
Stretch the elastic
cord on each side under
each respective black
shock knob as shown in
Fig. 7. There is an
opening mid way up
each side (with silver
(800) 893-2447 www.bobgear.com email- [email protected] Ph: (208) 375-5171
Fax: (208) 375-5172, BOB Trailers, Inc. 5475 Gage St. Boise, ID 83706
Revolution duallie Weather Shield instructions
MA0653
Fig. 1 Keep all Vents unobstructed.
Rear
Vents
Side
Vents
Front
Vent
Rear
Canopy
Flap
Fig. 2 Canopy Supports in position.
Aft Canopy
Supports fully
rotated back
Forward Canopy
Supports
Cinch each
Cord Lock
tight against
each Canopy
Fig. 3 Canopy Drawstring Adjustment
Fig. 4 Rear Canopy Flap in position.
Velcro
Fastened
Velcro
Fastened
Rear Canopy
Flap folded
over top
Fig. 6 Shield placed on Canopy
Align Weather Shield Seam with
Forward Canopy Supports
Elastic
Cord
End
Loop
Fig. 7 Elastic cord attachment
Elastic Cord
Under Black
Shock Knob
Silver
Reflective
Fabric
Elastic Loop
Around Black
Shock Knob
Fig. 5 Rear Vents unobstructed.
Air Passages
