BMW Z8 2000, Руководство пользователя

Страница: 145 / 172

144 n
Jump starting Towing
6 Start the support vehicle's engine
and let it run
7 Start the engine on the vehicle need-
ing the jump start, and allow it to run
as usual. If the first start attempt is
not successful, wait a few minutes
before another attempt in order to
allow the discharged battery to
recharge
8 Before disconnecting the jumper
cables from your BMW, turn on the
lamps, set the blower to the highest
speed and allow the engine to run for
at least 10 seconds. This will prevent
a voltage surge from the voltage reg-
ulator to the electrical accessories
9 Then disconnect the jumper cables in
reverse sequence.
Have the battery recharged if necessary.
Tow fitting
The screw-in tow fitting is stored in the
onboard tool kit; be sure that it remains
in the vehicle at all times. This fitting
is designed for installation in the tow
sockets located at the front and rear of
the vehicle. It is intended for towing on
paved road surfaces only.
It should not be used to pull a vehicle
out of deep snow, mud, sand, etc.
Always observe all applicable towing
laws and regulations.
Access to tow sockets
Front
The uppermost grille stub is clipped on
the grille – which is located below the
main grille on the lower right – and this
grille can be pulled off, if you pull for-
ward on it.
520de081
Rear
Use a screwdriver to press sideways on
the opening to remove the cover (arrow).
Screw the tow fitting in until it bot-
toms firmly. If this is not done, the
threads could be damaged.
Do not tow the vehicle by any compo-
nents of the running gear, or lash them
down in any way. If you do so, the com-
ponents could be damaged, leading to
possible accidents.
<
Use only a nylon towing strap to tow
the vehicle. The inherent resilience of
this material helps protect both vehicles
from sudden jerking movements.
520de065
Online Edition for Part No. 01 41 0 155 083 - © 03/00 BMW AG