BMW S 1000XR, Руководство пользователя для мотоциклиста

Страница: 122 / 237

The
RAIN
,
ROAD
and
DY-
NAMIC
riding modes are set up
for riding with standard tyres re-
commended by BMW Motorrad.
The
DYNAMIC PRO
riding
mode is for tyres with very good
grip, surfaces with a very high
level of grip, and one-up riding.
Consequently, you must always
bear the following in mind with
regard to your selection of a rid-
ing mode:
The sportier the setting, the
greater the challenge to your
riding skill!
It is the rider's responsibility to
select the correct riding mode.
For example, the DYNAMIC
PRO riding mode is totally un-
suitable for wet surfaces.
Mode changes
A changeover of the functions in
the engine management system,
the ABS and the ASC or, as ap-
plicable, the DTC systems while
riding is possible only in certain
operating states:
No drive torque at the rear
wheel
No brake pressure in the brake
system.
One of the following precondi-
tions has to be satisfied in order
for this condition to be achieved:
The vehicle is at a standstill
with the ignition switched on.
With the vehicle on the move,
the throttle twistgrip must be
turned back and the brake
levers must be in the released
positions.
The desired riding mode is ini-
tially preselected. The mode
change does not take place until
the control systems in question
are all in the appropriate state.
The selection menu does not
disappear from the display until
the change of riding modes has
completed.
Riding mode RAIN
Wet roads
The
RAIN
riding mode offers
safety and directional stability on
wet roads or roads with a simil-
arly low coefficient of friction.
ABS
The ABS always intervenes
early enough to prevent as ef-
fectively as possible the wheels
from locking and the rear wheel
from lifting off the ground.
Maximum assistance with in-
tegral pressure build-up when
only the handbrake lever is
pulled.
ABS for the rear wheel is
switched on.
Rear-wheel lift detection is
switched on. The rear wheel
8
120
z Engineering details