BMW C 650 GT, Руководство пользователя для мотоциклиста

Страница: 62 / 194

If you switch the ignition off
then on again and the ASC
light comes back on, there is a
fault in the ASC.
Calibration
Calibration is the process of ad-
apting control to the effective
tyre radii of the front and rear
wheels.
Effective tyre radius
Effective tyre radius depends
on tyre make, tread depth, tyre
press and the load carried on
the vehicle.
Always re-calibrate the ASC
after changing a tyre or tyres
to adapt the system to the
changed tyre radii.
As tyre wear progresses, reg-
ularly re-calibrate the ASC so
that it can operate as effect-
ively as possible.
It is not necessary to recalib-
rate the system after remov-
ing and reinstalling a wheel to
which no changes have been
made, for example when a
wheel is removed so that the
brakes can be serviced.
Calibrating ASC
Requirement
Reduced reserves of stability
of ASC control following a tyre
change.
ASC Switching on ( 59).
SETUP ASC ON
appears on the
display.
Long-press INFO 2 to start
calibration.
CAL.
3 flashes.
ASC warning light starts to
show.
There are no functions as-
signed to buttons
1 and 2 .
The only way to exit this menu
item is to switch the ignition of
and then on again.
Calibration is stated and ex-
pects the Maxi­Scooter to be
ridden forward.
ATTENTION
ASC is not available until
calibration is completed
Risk of falling
Use a smooth and level stretch
of straight road with good grip
for the calibration procedure.
Ride in a straight line and re-
main for 6 seconds in the fol-
lowing speed range, riding at
as steady a speed as possible.
4
60
z Operation
https://www.motorcycle-manual.com/