BMW Motorrad S 1000 R, Руководство пользователя для мотоциклиста

Страница: 28 / 172

Possible cause:
The number-plate carrier has
been removed; the motorcycle's
on-board electronics know that
the flashing turn indicators are
not installed on the motorcycle.
Installing number-plate carrier
(
77).
If the number-plate carrier
is removed in preparation
for a race-track session, the elec-
tronics detect a bulb failure and
the appropriate warning appears
on the display. Activating the
EQIP WARN LAMP
function in
the
SETUP MENU
suppresses
this warning.
Motorcycle dropped
VDS!
(Vertical Down Sensor)
appears on the blank display.
Possible cause:
The drop sensor has detected a
drop and has cut out the engine.
Bring the motorcycle to the
upright position.
Switch the ignition off and
then on again or switch the kill
switch on and then off again.
Drop sensor defective
VDS!
(Vertical Down Sensor)
appears on the display.
Possible cause:
A defect in the drop sensor has
been detected.
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
ABS self-diagnosis not
completed
ABS warning light flashes.
Possible cause:
ABS self-diagnosis not
completed
The ABS function is not avail-
able, because self-diagnosis
did not complete. (The motor-
cycle has to reach a defined
minimum speed for the wheel
sensors to be checked: min
5 km/h)
Pull away slowly. Bear in mind
that the ABS function is not
available until self-diagnosis has
completed.
ABS switched off
ABS warning light flashes.
Possible cause:
The rider has switched off the
ABS system.
Switch on the ABS function
(
44).
3
26
z Status indicators
ProCarManuals.com