Operation
Cleaning and Care
Turning on the heater
1 Depress and turn control knob clockwise to OFF position
2 Fully open gas valve
3 Depress control knob and turn knob counter-clockwise to IGNITE position, then to
PILOT position (you will hear 2 clicks).
4 With the pilot light lit, keep control knob depressed for 30 seconds
NOTE: If the pilot light has not ignited, turn heater control knob to OFF position, fully
close gas valve, wait 5 minutes, then repeat steps 2–4 of the Lighting Instructions.
NOTE: If the pilot light ignites but does not stay lit, turn heater control knob to OFF
position, fully close propane gas valve, wait 5 minutes, then repeat steps 2–3. Now,
using a lighter, ignite the pilot light through the ignition hole on the emitter screen.
Once the pilot light is lit, depress control knob for 30 seconds.
5
After depressing the control knob for 30 seconds, turn control knob to LOW. To increase
the temperature, turn towards HIGH
Turning the heater off
1 Fully close gas valve
2 Turn control knob clockwise to OFF
position
Off: the heater stops operation
Hi: maximum temperature position
Lo: minimum temperature position
Cleaning
•
Wipe off powder coated surfaces with soft, moist rag. Do not clean heater with cleaners
that are combustible or corrosive
• Remove debris from the burner to keep it clean and safe for use
• Cover the burner unit with the optional protective cover when the heater is not in use
Storage
• Always close the gas valve of the gas cylinder after use or in case of a disturbance
• Remove the pressure regulator and the hose
• Check the tightness of the gas valve and for damage If you suspect a damage, have it
changed by your gas dealer
• Never store liquid gas cylinder in a sub-terrain, or at places without adequate air
ventilation
Pointer
Variable control knob
HIGH
LOW
PILOT
Push
to
turn
IG
NIT
E
OFF
25
