21
V1.1
SmartBus P900-TI6N USER MANUAL
L
E
D
e. Telephone Remote Disarm
For information on how to DISARM Partition system, please refer to PARTITION
DISARMING at page 34 (Section 8.15).
[USER CODE] + [#]
1. To disarm the system, enter a valid 4-digit
[USER CODE]
followed by
[#]
key before
expiry of the entry delay time.
2. Enter the premises through a designated
ENTRY/EXIT
zone; entering via other zones will
trigger an alarm instantly.
3. The
ENTRY
delay begins once the
ENTRY
zone is violated.
4. The keypad audible indicator will sound for the duration of the
ENTRY
delay to indicate
that a valid user code is required.
5. If the
P1
indicator remains illuminated, an error has been made while entering the user
code. Press
[
]
key and re-enter the user code.
6. Once the system is disarmed, the
P1
indicator will extinguish and the keypad audible
indicator will stop.
7. If the
MEMORY
indicator is flashing upon entry there has been an intrusion. Call for
assistance. The intruder may still be inside.
8. If no valid user code has been entered by the end of the
ENTRY
delay period, an
ALARM
condition will be registered and stored into the system
MEMORY.
9. If programmed to do so, the keypad will be locked and non-responsive for a
preprogrammed period for certain number of incorrect user codes, which are entered
consecutively more than the keypad lock counter.
10. If the
ENTRY
delay is too short, have your installer to change the
ENTRY
delay period.
1. Your system can be programmed to automatically
DISARM
itself according to a
programmed schedule.
2. Please refer to User Programming section
– Program Auto Disarm Timer.
8.5.1 KEYPAD DISARMING
8.5.2 AUTO TIMER DISARMING
