Bluetechnix Argos3D - P100, Руководство пользователя

Страница: 13 / 25

Hardware User Manual - Argos3D – P100 Last change: 22 August 2013
Version 1.5
6.2 Modulation Frequency
The modulation frequency is set to 30 MHz per default. Other modulation frequencies can be set using the
SDK. Be aware that this changes also the ambiguity range of the camera. Refer to our software
documentation to see how to change the modulation frequency.
Software and documentation

https://support.bluetechnix.at/wiki/Argos%C2%AE3D_P100_Camera
6.3 Ambiguity Range
The ambiguity range of the camera is per default approximately 5m. If you have objects which are more than
5 meters away from the camera, they will be shown as to be very close to the camera. If you need an
enhancement of the ambiguity range without changing the modulation frequency please contact our support
team at
support@bluetechnix.com .
6.4 Frame-rate vs. Integration Time
The camera integration time is limited by default to 2.7ms. It can be enhanced by using the command
DisableIntegrationTimeCheck ( Refer to 7.7.1).
Caution
Be careful when disabling the integration time limit.
Higher integration times may require enhanced cooling. Be aware to provide enough cooling in
that case! (Refer to 7.4.2).
6.5 External Trigger and Modulation Signal Interface
6.5.1 External Modulation Signal
The camera provides an external connector (refer to 7.5.1) where the modulation signal is provided as LVDS
signal to synchronize with an external light source. This signal must be enabled by software before it can be
used. Please refer to our software documentation (see 7.7.1) to see how to activate the external modulation
signal.
6.5.2 External Hardware Trigger Signal
The camera provides an external connector (Refer to 7.5.1) where a hardware trigger can be applied. The
hardware trigger must be enabled by software. Please refer to our software documentation (see 7.7.1) to see
how to enable the hardware trigger. Refer to 7.5.1 for the signal description.
© Bluetechnix 2013 Page | 12