ASSEMBLY INSTRUCTIONS
Hello friend! You are about to try a new way of assembling kits. Much easier and
faster. However, we need to pay attention to some guidelines to facilitate our assembly:
1- all indications engraved on each piece must always be visible;
2- they must always be facing forward, in the case of horizontal and outward in the
case of vertical;
3- the fittings are accurate, but if there is a need for any adjustment, do it;
4- do not glue definitively before making sure it is in the correct way, so assemble
the parts before gluing them;
5- you will need sandpaper of various thickness, CA glue and / or wood, in addition
to epoxy;
6- all assembly is illustrated on the A1 format sheet with this kit. The guidelines that
may not be there, will be here.
Knowing all the guidance presented, we will start the work. Good assembly and good
flights!
VERTICAL STABILIZER:
- Let's start with the easiest one, the vertical stabilizer. Find piece R1 and glue R2
and R3 to its ends. Close with R4 and finish with crosspiece R5. The control surface, find
R6 and glue to it R7,R8 and closing with R9. Lock the system with R10. Finished!
HORIZONTAL STABILIZER:
-in the same way, join parts E1, E2 and E3. Locking the structure, glue E4 as
illustrated. Ready! The control surface starts with E5, glue the two pieces E6 and then the
two E7. Close the ends with E8. Lock the entire system with E9 parts.
HOOD:
-very simple. Join structures H2 to H1. Paste MAG. behind MAG.H2. Once the set
is assembled, glue it to H2, as shown in the drawing. To finish, paste H3 on its half, on H1
on its front. See illustration.
