Attaching the Tobii I-13 or I-16 to a Mount’n Mover with a Tilt Plate
DP-T5
Tobii I-13
Tobii I-16
1
DP-T5
page 1 of 4
The DP-T5 consists of the Quick Connect Receiver
(QCR), the DP-1x2, and four 8-32 x 2” screws.
QCR
DP-1x2
Use the four screws that come with the DP-T5 to go
through the Quick Release Plate (QRP), through the
DP-1x2 and into the Quick Connect Receiver (QCR)
Attach the DP-1x2 to the QCR with TWO of the
2” screws
(use the two counter sunk holes)
Two Counter sunk holes
Reconfigure screws for an I-16
Quick Release Plate is attached using the other TWO 2”
screws. Go through the QRP, the DP-1x2, and into the
lower two holes on the QCR.
Counter sunk holes
two screws (8-32 x 2”) through
top two holes on the QRP
QRP
QRP
QCR
QCR
DP-1x2
Slide the DP-T5 onto the connecting grooves on
the Tobii device plate until it “clicks” in place.
Slide Up
Tobii Device Plate
Slide the DP-T5 onto the connecting grooves on
the Tobii device plate until it “clicks” in place.
Tobii
Device
Plate
Slide
Up
*
Close up of
counter sunk
holes at the top
x4 (8-32 x 2”)
(
8-32 x 2”)
2
Assemble QRP to DP-T5
Attach QCR to Tobii Device
3
DP-1x2
Attach QRP to DP-T5
2
Attach QCR to Tobii Device
3
Attach the DP-1x2 to the QCR
1
DP-T5
Remove the
QRP from the
Mount’n Mover
Tilt Plate
The other two
screws are holding
the parts together.
Take apart before
step #2
