BlueSens BlueVary, Обновление руководства

Страница: 10 / 31

BlueVary UPDATING MANUAL
Rev 200504 002 9
EN
Selecting Admin user 4.3
In the submenu
Set user level the access rights can be chosen according to the following list:
user level Access rights Code
Normal user Reading rights Unnecessary
Calibration user Normal user + calibration rights (1-point / 2-point) 0001
Installation user Normal user + configuration rights 2020
Admin Unlimited rights 1818

After a reset or power up user level always switches to Normal User !
To prepare the
BlueVary for the firmware update the Admin has to be selected. Place the cursor with
the  buttons in front of the Admin . By pressing OK button the user is selected. Now proceed with
code input. Select the Code line (  + OK ) and insert the code 1818 (  + ESC ).
To accept the input go to Apply settings (  ) and press OK .
Depending on whether the code was right or not one of the following messages appear:
The message has to be confirmed by pressing OK .
Fig. 8: Schematic of the submenu user level
Fig. 9: Possible messages after trying to apply settings in the User menu