S D S 2 0 0 P I P E D R A I N C L E A N E R
12
General Maintenance
Note
SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.
DON’T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!
Ø
Inspect electrical cords and electrical connections.
Ø
Keep machine clean and free of debris.
Ø
Flush cables with water after each use. Occasionally lubricate cables and couplings.
Ø
Check for misalignment, binding and breakage of all moving parts. If damaged, repair tool before use.
Ø
Check the cutters for sharpness or damage.
Ø
Clean clutch teeth with wire brush. Check the attrition on the 3-jaw clutch. If the points are worn, replace with
identical piece.
Ø
After each use coat all moving parts (including clutch driver) with corrosion resistant oil.
Occasional Maintenance
Ø
Check brushes for wear and replace if worn.
Ø
Grease rocker arms and main bearings every 3-6 months.
Ø
Grease main bearings thru grease fitting inside clutch handle slot.
Ø
After a lot of use, clutch jaws may need to be replaced.
o
Remove the screws that hold the front guard to the housing. Remove screws that hold the nosepiece on.
o
Slide out clutch driver and replace jaws.
o
Put nosepiece assembly and guards back on.
§
WARNING: DO NOT operate machine with guards removed.
Ø
After a lot of use, the V-Belt may need to be tightened.
o
Remove V-Belt Guard
o
Loosen locknut, turn bolt until V-Belt tightens. Tighten lock nut back up. Replace guard.
Chapter
5
