background image

Federal Communication Commission Interference Statement 

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed 
to provide reasonable protection against harmful interference in a residential 
installation.  This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications.  However, there is no 
guarantee that interference will not occur in a particular installation.  If this 
equipment does cause harmful interference to radio or television rec eption, which 
can be determined by turning the equipment off and on, the user is encouraged 
to try to correct the interference by one of the following measures: 

 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that 

        to which the receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with Part 15 of the FCC Rules. Oper ation is subject to the 
following two conditions: (1) This device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation. 

 

FCC Caution:

 Any changes or modific ations not expressly approved by the party 

responsible for compliance could void the user's authority to operate this 
equipment. 

 

IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 

This equipment complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and operated with 
minimum distance 20cm between the radiator & your body. 
This transmitter must not be co-located or operating in conjunction with any other 
antenna or transmitter. 
 
 

THIS PRODUCT COMPLIES WITH 47CFR PART 68. 
THIS PRODUCT HAS BEEN CERTIFIED BY A TCB. 
 
 
 
 

       

     

 

  

Содержание AirBase










Отзывы: