BlueBox niji, Руководство пользователя

Страница: 30 / 31

29
www.BlueBoxOptics.com V2.4
niji
8.4 Channel On/Off
To set a channel On or Off use the following command structure.
D,1,0
<Command>, <Channel Select (1-7)>, <Channel On/Off (1 or 0)>
8.5 Channel Active Set: Example
Should we wish to set Channel 2 to Active. The command string would be constructed
as follows:
D,2,1
8.6 Channel Identification
Channels of the equipment are referenced from the software, reading left to right.
The channel allocations are as follows:
Channel Wavelength
1 Ultra Violet
2 Royal Blue
3 Blue
4 Cyan
5 Green/Amber
6 Red
7 Far Red
8.7 TTL Command String
The TTL command string is split into four parts. These are the command identifier,
function ON/OFF, Active state and logic state. The TTL string is constructed as follows:
TTL,0,0,0
<Command>, <ON/OFF>, <Active State)>, <Pull up/down>
Use the following logic level to set the Active State and the Logic State. The TTL active
state can be defined as either High(1) or Low(0). The internal logic can be either Pull
Up(1) or Pull Down(0).
8.8 TTL Set: Example
Should we wish to set TTL ON, with Active Low and a Pull Down. The command string
would be constructed as follows:
TTL,1,0,0