BlueBox IDTRONIC HF, Руководство по протоколу связи

Страница: 19 / 37

BLUEBOX Gen.2 HFM Page 19 of 37
Byte Value Description Notes
6 0x03 Don’t care value 0x03 suggested value
7 0x..
Filter time:
• Decimal 0 … 99 for time in seconds
(0 … 99 seconds)
•
Decimal 100 … 199 for time in minutes
(0 … 99 minutes)
8 0x..
Flags: single bits are dedicated to disable
(0 value) or enable (1 value) functions:
•
Bit 7: automatic buzzer management
•
Bit 6: automatic output 1 management
• Bit 5 … bit 1: not used
•
Bit 0: to disable ‘continuous’ mode
The answer to this command is given in short form through the ‘Reply Ack’ /
‘Reply Nak’ flags (this command don’t ‘produce’ data).
Note: after the command execution, the BLUEBOX resets itself to apply the
new parameters.
3.11 Operating Parameters Reading
This command is used to get the values of the operating parameters of the
BLUEBOX .
Byte Value Description Notes
1 0x2A Command code
If command is not successfully executed, the answer is given in short form
through the ‘Reply Ack’ / ‘Reply Nak’ flags; otherwise, the BLUEBOX answers:
Byte Value Description Notes
1 0x2A Command code
2 0x.. Don’t care value
3 0x.. Don’t care value
4 0x.. Don’t care value
5 0x.. Don’t care value
6 0x.. Don’t care value
7 0x..
Filter time:
•
Decimal 0 … 99 for time in seconds (0 …
99 seconds)
• Decimal 100 … 199 for time in minutes
(0 … 99 minutes)