BlueBox IDTRONIC HF, Руководство по протоколу связи

Страница: 18 / 37

BLUEBOX Gen.2 HFM Page 18 of 37
Byte Value Description Notes
1 0x3C Command code
2 0x03 Command code
If command is not successfully executed, the answer is given in short form
through the ‘Reply Ack’ / ‘Reply Nak’ flags; otherwise, the BLUEBOX answers:
Byte Value Description Notes
1 0x3C Command code
2 0x..
Address:
Decimal 1 … 126
3 0x..
Buffers length:
• 0x00 -> 8 bytes
•
0x01 -> 12 bytes
•
0x02 -> 16 bytes
• 0x03 -> 20 bytes
•
0x04 -> 32 bytes
•
0x05 -> 64 bytes
4 0x.. Don’t care
5 0x.. Don’t care
6 0x.. Don’t care
7 0x.. Don’t care
8 0x.. Don’t care
3.10 Operating Parameters Programming
This command is used to set the operating parameters of the BLUEBOX that
are: hold time (00 ... 99 seconds), filter time (0 ... 99 seconds / 0 ... 99
minutes), flag for ‘automatic’ buzzer management (disabled, enabled), flag for
‘automatic’ output 1 management (disabled, enabled) and flag for ‘continuous’
mode (disabled, enabled).
Byte Value Description Notes
1 0x2F Command code
2 0xFF Don’t care value 0xFF suggested value
3 0x48 Don’t care value 0x48 suggested value
4 0x20 Don’t care value 0x20 suggested value
5 0x01 Don’t care value 0x01 suggested value