-35-
Revision 5/F3534
©
Moffat Ltd, April 2005
Turbofan Convection Oven
Door Seals
6.3.22 DOOR SEALS
1) Open oven door.
2) To remove, hold at their centre point and pull
forward until they unclip
3) Refit
new
seals.
Note:
Fit top and bottom seals first, with the open
side of the seal facing downwards. Fit side
seals with open side facing outwards.
Figure 6.3.32
6.3.23 DOOR PIVOT BUSHES
1) Remove door as per steps one to three of
section 6.3.19.
2) Door bushes can now be removed and
replaced.
3) Reinstall door by reversing steps one to three
of section 6.3.19.
6.3.24 OUTER GLASS (E311MS)
Door Pivot
Bushes
Door Catch
Plate
(4 screws)
Top Door
Screws
Door Handle
(4 screws)
Bottom Door
Screws
1) Remove door as per steps one to three of
section 6.3.19.
2) Remove door bushes, catch plate (4 screws),
handle (4 screws), top and bottom screws (4).
Figure 6.3.33
3) Place door on bench with door outer facing
up. Lift door outer up removing it from door
assembly. Remove outer glass.
4) To replace, clean inner and outer glass,
ensure the silicone rubber seal has not been
displaced and refit door outer. Reassemble in
reverse order.
5) Reinstall door by reversing steps one to three
of section 6.3.19.
6.3.25 INNER GLASS (E311MS)
Door Glass
Door Outer
Door Inner
Outer Seal
Glass Clamp
Inner Seal
Figure 6.3.34
1) Remove outer glass as per steps one to three
of section 6.3.23
2) Uncrimp the retaining tags and remove glass
clamp.
3) Remove inner glass.
4) To replace, ensure the silicone rubber seal
has not been displaced. Clean the glass and
refit it. Place the glass clamp in position and
crimp the retaining tags over to hold the glass
in place. Refit outer glass as above.
6.3.26 OUTER GLASS SEAL (E311MS)
1) Remove the door outer glass (refer 6.3.24).
2) The outer glass seal can now be removed
and replaced.
NOTE:
When fitting new seal, ensure join is at
top of door.
