Blue Seal Evolution GPE506, Руководство по эксплуатации

Страница: 11 / 27

9
Installation
5. Connect neutral and earth conductors to neutral stud and earth stud respectively.
6. For all connections ensure that conductors are secure and appropriately terminated.
7. Tighten the cable gland to secure against tension on the cable.
8. Check that the polarity of each connection is correct to the mains connection terminals markings on
the appliance.
NOTE:

This appliance must be earthed.

Fixed wiring installations must incorporate an all-pole disconnection switch.
9. Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs
so that the appliance is level and at the correct height.
10. Connect the power supply to the appliance.
11. Check that the electrical supply is within the input rating specification, refer to the 'Specifications'
section).
Commissioning
Before leaving the new installation;
Check the following functions in accordance with the operating instructions specified in the
'Operation' section of this manual.
 Light the Griddle Pilot Burner.
 Light the Griddle Main Burner.
 Check the Griddle Low Fire Operation.
 Check the Oven Heating.
 Check the Oven Thermostat Operation.
 Check the Oven Fan Operation (GPE56 and GPE58 Ovens Only).
Ensure that the operator has been instructed in the areas of correct lighting, operation, and
shutdown procedure for the appliance.
This manual must be kept by the owner for future reference and a record of the
Date of Purchase, Date
of Installation and Serial Number of the Appliance recorded and kept with this manual. (These
details can be found on the Rating Plate attached to the bottom right hand corner of the
bottom sill. Refer to the ‘Installation’ section) .
NOTE: If it is not possible to get the appliance to operate correctly, shut ‘Off’ the gas and electrical
supply and contact the supplier of this appliance.
Changing supply from 3 phase to single phase will increase electrical current
loading on supply cable. Ensure supply cable used is of a sufficient size for
current loading, refer to 'Electrical Supply Requirements' table.
Caution