background image

PRODUCT DESCRIPTION

 

 

The BG-One is an electronic oil and fuel detector with smart bilge pump switch that uses patented technology to detect the presence of oil or fuel and 
integrates with the bilge pump system. Pump power is controlled by the BG-One. If oil or fuel is detected, the BG-One will prevent pumping the oil out 
of the bilge by turning the pump power OFF. If water or other liquid is detected, the pump will be turned ON. The BG-One is CE and ISO 8846 Marine 
Ignition Protection Certified, tested to ABYC-1500 standards.

There are three modes that are available in the BG-One which are configured using the BGI Config App, which can be downloaded from the App Store or 
Google Play. The App is used on a mobile device with Bluetooth to wirelessly connect to the BG-One device. The App allows selection of the operating 
mode and will report the input voltage level, system temperature alarm state, and pump switch state. The BGI Config App also allows changing the name of 
the device for easy identification. The App can only configure the device in the first minute that it is powered up.

INSTALLATION

 

 

The BG-One is designed for mounting near the bilge pump in a vessel. 
It should be mounted approximately 2” above the bilge pump outlet as 
shown in the Blue Guard Installation Guide. A mounting bracket and three 
#8x0.75” 316 stainless steel screws are provided to allow mounting to a 
vertical or horizontal structure. 

If the device is mounted on the bottom of the hull of the vessel the  
strainer should be mounted first and then the main unit attached. 

The Blue Guard Installation Guide shows the wiring for all supported  
configurations. All wiring connections are made using heavy-duty 14 
gauge marine grade wire. All wiring should be done by a licensed  
electrician following NEC code. 

INSTALL STEPS: 
1) Locate proper mounting location for the BG-One, near the bilge pump  
  and approximately 2” above the pump outlet. 

2) Install mounting bracket to bulkhead using two #8x0.75” 316 stainless  
  steel screws provided*. 

3) Attach the BG-One into bracket with product label facing up, and wiring  
  close to bracket. 

4) Run wiring to BG-JBox, BG-CP, bilge pump, and battery depending on  
  the installation chosen from the Blue Guard Installation Guide. Secure  
  the wiring. It is recommended that connections to the BG-JBox be  
  made using 14 AWG crimp spade lugs at the ends of the wires. 

5) Apply power to the system. 

6) Connect to the BG-One using the BGI Config App, set the Mode if not  
  using Mode A (Marina). The App can be used to view the system  
  parameters at any time, but the user must connect within one minute of  
  powering on the BG-One device to configure it. 

*The BG-One can also be mounted on the hull using three #8x0.75” 316 stainless steel screws. 
Mount the strainer first, then attach the BG-One into place.

SMART SWITCH MODES OF OPERATION

 

 

Mode A (Marina) 
- Turns pump ON when water is detected
- Turns pump OFF when oil or fuel is detected
- Turns pump back ON when only water is detected 

Mode B (Marine Sanctuary) 
- Turns pump ON when water is detected 
- Turns pump OFF when oil or fuel is detected 
- Stays OFF until alarm and bilge is cleared (Requires power cycling  
  of device)

Standard Mode (High Seas) 
Bilge pump switch only (will turn ON or OFF for any liquid)

Strainer

Detachable Mounting Bracket

 BG-One 

Smart Bilge Pump Switch with Oil and Fuel Detector

U S E R   M A N U A L

Отзывы: