4
STRONGARM™ ML10 VEHICLE RESTRAINT—OWNER’S MANUAL
ISSUE DATE: SEPTEMBER 29, 2014 REV.0 (PART # 038-538E)
2.0 INTRODUCTION
The following is a quick reference to important procedures that
must be followed while using the Vehicle Restraint System. It is
not intended to cover, or suggest that it does cover, all procedures
necessary to ensure safe operation. All operators should be aware
of and abide by all workplace safety regulations applicable to
the operation of the Vehicle Restraint System. These laws and
regulations include but are not limited to:
• The Occupational Safety and Health Act
• Canada Occupational Health and Safety Regulations
• Occupational Safety and Health Acts for Individual States
(USA)
For additional information on these regulations as well as industry
standards that may apply to this product, please contact:
American National Standards Institute (ANSI)
1430 Broadway
New York, NY 10018
Telephone: 212.642.4900
www.ansi.org
Also a member of:
Loading Dock Equipment Manufacturers
A Product Section of Material Handling Industry of America
A Division of Material Handling Industry
8720 Red Oak Blvd, Suite 201
Charlotte, NC, 28217-3992
Telephone: 704.676.1190
www.mhi.org/lodem
2.2 EXCLUSION OF LIABILITY
The manufacturer assumes no liability for damage or injury to
persons or property which occur as a result of defects or faults in
or incorrect use of the Vehicle Restraint System. The manufacturer
also assumes no liability for lost profits, operating downtimes, or
similar indirect losses incurred by the purchaser. Injury to third
parties, irrespective of its nature, is not subject to compensation.
The manufacturer reserves the right to make changes at any time
to the modules, components, and accessories, concurrent with
its continuing product improvements and development program.
Specifications, operating instructions, and illustrations included in
this manual are subject to change without notice. Please contact
manufacturer for the latest information.
2.3 MANUFACTURER’S NOTE
The Vehicle Restraint has been carefully inspected and tested at
the manufacturer’s plant prior to shipment, but should be checked
upon receipt for transport damage. Any observed transport
damage is to be listed on the signed copy of the freight document.
Notify the freight forwarder of any damage WITHIN 48 HOURS.
2.1 WARRANTY INFORMATION
Thank you for purchasing Blue Giant products. We appreciate your
business, and are confident that our product will serve you for
many years to come. In the event that you experience a problem
with our product, our Warranty Center is here to support the
Blue Giant Product(s) that you have purchased.
To validate warranty on recently purchased equipment,
please complete and submit your information with our
online Warranty Registration at
www.BlueGiant.com
.
For more information about Blue Giant Warranty Support, please
contact your local Blue Giant Equipment dealer, representative or
authorized partner near you. You may also visit www.BlueGiant.
com or phone 1.905.457.3900.
DEALER INFORMATION
Name:
Contact:
Telephone:
*
NOTE
that failure to validate warranty at the time of receipt can
seriously affect the outcome of any claim.
