Blue Diamond EXTREME DUTY SNOW BLOWER 68, Руководство по эксплуатации и обслуживанию, Страница: 36 / 70

36
Extreme Duty Snow Blower Operation and Maintenance Manual
Operation
Snow Blower Removal
NOTE: Rear skid pads must be fully retracted
before removing the snow blower from
the machine.
Before removing the snow blower from the
machine, fully retract all rear skid pads.
NOTE: Put the snow blower on planks or
blocks before removing the snow
blower from the machine to prevent the
snow blower from settling or sinking in
soft / wet ground.
Lower the lift arms and put the snow blower flat on
the ground.
Stop the engine and release auxiliary hydraulic
pressure. (See machine’s operations manual for
correct operation.)
Exit the machine. (See “Leaving The Operator’s
Position” on page 24.)
WARNING
AVOID SERIOUS INJURY OR DEATH
Before you exit the machine
:
• Lower the lift arms, put the attachment
flat on the ground.
• Stop the engine and engage the parking
brake.
• Always keep your feet on the pedals or
footrests and hands on the controls.
• Move all controls until they are LOCKED
or in the NEUTRAL position.
SEE THE MACHINE’S OPERATION MANUAL
FOR MORE INFORMATION.
Disconnect attachment hydraulic hoses from the
machine.
Disengage locking pins / wedges. (See the
machine’s Operator’s Manual for correct
procedure.)
Disconnect the attachment control harness.
Enter the operator’s position. (See “Entering The
Operator’s Position” on page 24.)
Slowly tilt the machine’s mounting plate forward
until the attachment mounting frame is free from
the machine’s mounting plate.
Drive the machine slowly backward, away from
the attachment.