Blue Coat SG810 series, Руководство по установке

Страница: 55 / 110

P/N 231-02941 SG810 Installation Guide page 55
Logging in to the SG810 CLI
You can connect to the SG810 CLI (a) by using a direct serial connection or (b) by
using an SSH client, such as PuTTY or F-Secure. To connect to the SG810 CLI using
Telnet, you must first enable the Telnet-Console. Refer to the “Managing Port
Services” section of the
Blue Coat ProxySG Configuration and Management Guide .
Note: The CLI uses two passwords: The console password is required to
establish a connection to the interface, and the enable password can
be set to restrict access to the privileged mode configuration
options. If you forget the username or password, you can reset them
using either the front panel control buttons and LCD or a serial
terminal or PC.
To log in to the SG810 CLI using a direct serial connection:
1
To set up the serial connection, complete steps 1 and 2 in the section “Initial
Configuration Using a Serial Console” on page 34.
2
After the system has finished booting, press the computer keyboard Enter key
three times. The following text displays:
Figure 2-13: Serial Console Login Page
3
Enter
1
to select the Command Line Interface option.
4
Enter the username and password when prompted. If the username has not
been changed, the default is
admin
. The password is the one you wrote down
or configured during initial configuration.
Welcome to the Appliance Serial Console
Version: SGOS 4.1.0.0, Release id: 12345
-------------------------MENU-------------------------
1) Command Line Interface
2) Setup Console
------------------------------------------------------
Enter option: