Blue Coat SG810 series, Руководство по установке, Страница: 53 / 110

P/N 231-02941 SG810 Installation Guide page 53
Section E: Logging in to the SG810
Once the SG810 is configured, the LCD will cycle through and display various
messages, such as
CPU Utilization
and
Freshness
.
After you have completed the initial configuration and connected the SG810 to
the network, you must log on to the SG810 to fully configure the appliance. You
may fully configure the SG810
using two methods.
• Use a browser to access the SG810 Management Console Web interface.
• Use a direct serial connection or an SSH Client to access the SG810
command-line interface (CLI).
Important: Blue Coat recommends that you set up a secure SSL connection
for greater security. For instructions, refer to the
Volume 5:
Securing the ProxySG in the Blue Coat ProxySG Configuration and
Management Guide .
Logging in to the SG810 Management Console
The Management Console is a graphical interface for configuring and managing
all aspects of the SG810. You can log on to the Management Console using a
browser.
To log on to the Management Console using a Web browser:
1
Start the SG810.
2
Open a browser. Refer to the release notes of your SGOS version for details on
compatible browsers.
3
Enter the IP address configured during initial configuration, followed by the
port number
8082
. For example, enter:
https://10.25.36.47:8082
.
4
Click
Yes
in the Security Alert dialog; enter a username and password in the
Enter Network Password dialog that displays. If the username has not been