Blue Coat SG510 Series, Руководство по установке

Страница: 19 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 19
Chapter 2: Configure a SG510
You need to configure a SG510 the first time you power it on to set the basic
network parameters and to make sure that the SG510 hardware and software are
working properly.
Overview of First-Time Configuration
There are four ways to configure a SG510 the first time you power it on. Each of
these methods of configuring a SG510 let you make the basic network settings
required to test the connection and functionality.
Configuration
Method
Description
Front Panel Use the front-panel LCD and buttons.
(This is the quickest and easiest way to do a first-time configuration.
To use the front panel method, go to
“Configuring the SG510 with
the Front Panel Features”
on page 21.
Serial Console Use a direct connection between the system and a PC, or a serial
terminal, or a stand-alone serial console terminal.
To use the serial console connection, go to
“Initial Configuration
Using a Direct Serial Port Connection”
on page 38.
Web Browser Use a Web browser. To use this method for SGOS 5.1.1.x and later,
you must first configure the IP address of the SG510 using the serial
console or front panel. Blue Coat recommends using the Web
browser configuration method if you are running SGOS 5.1.1.x or
later.
To use the Web browser configuration method, go to
“Initial
Configuration with a Web Browser”
on page 29.