Blue Coat SG210 series, Руководство по установке

Страница: 32 / 54

32 Blue Coat SG210 Installation Guide
To log in to the SG210 CLI using an SSH client:
Note: You must already have an SSH Client installed before proceeding with the following steps.
1
Start the SG210.
2
Launch your SSH CLI and enter the following settings as necessary:
• The IP address that you configured during initial configuration
• A port number, if necessary (Port 22 is the default)
• The username and password that you configured during initial configuration
3
At the command prompt, enter enable , then enter the enable password that you configured during
initial configuration:
SGOS> enable
Enable Password: ******
SGOS#
You are now in privileged mode.
4
At the privileged-mode command prompt, enter configure terminal to configure SG210 settings:
SGOS# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
SGOS#(config)
Refer to the Blue Coat ProxySG Configuration and Management Guide Suite or the Blue Coat ProxySG Command
Line Reference for information about using the CLI to configure the SG210.