Blue Coat SG210 series, Руководство по установке

Страница: 16 / 54

16 Blue Coat SG210 Installation Guide
2
Power on the SG210 and wait for the system to finish booting.
The following configuration alert displays:
Figure 2-8: Initial Setup—Configuration Alert
3
Press <
Enter
> three times. When the
Welcome to the ProxySG Appliance Setup Console
prompt
appears, the system is ready for the first-time network configuration.
Figure 2-9: Initial Setup—SG Appliance Setup Console
4
You can do one of the following:
❐
Type
M
to use the Manual Serial Setup Console. This option allows you to continue using the serial
console for fully configuring your SG210 appliance.
❐
Type
W
to use the Web Setup Wizard. This option requires you to assign the IP address, IP subnet
mask, and the IP gateway through the serial console, then you can continue the configuration
using the Web browser.
❐
Type
R
to use Director Registration.This option requires you to assign the IP address, IP subnet
mask, and the IP gateway for the SG210 and the IP address for the Director through the serial
console, before registering the SG210 with a Director.
Note: If you have removed the pass-through card, you are asked if you want to configure a
software bridge. If you enter
YES
, you must configure at least one bridge port and
associate a network interface with it.
******************* CONFIGURATION ALERT *******************
System startup cannot continue for one of these reasons:
(a) Need at least one adapter configured with an
IP address and subnet.
(b) Need the console password and enable password.
(c) Need to specify the trial edition.
********** SYSTEM STARTUP TEMPORARILY SUSPENDED **********
Press "enter" three times to activate the serial console
Welcome to the SG Appliance Setup Console
How do you want to set up the SG appliance?
M)anual setup using the serial console
W)eb wizard (after setting network configuration using the serial
console)
R)egister with Director (registration password required)
Choose setup mode: