42
ProxySG 900 Series Maintenance & Upgrade Guide
Using the CLI to Verify Disk Drive Installation
The following procedure describes how to use the CLI to verify disk drive installation.
Note:
These steps are applicable only to an appliance that has already been configured.
1.
Access the CLI:
a.
If the appliance is already configured, open an SSH session to the CLI and go to Step 2.
b.
If you replaced the only disk drive in the appliance and have not yet configured it,
connect to the appliance serial console and configure the appliance’s basic settings.
Then, press Enter three times to access the CLI and go to Step 2.
2.
Type
enable
.
3.
Enter the enable password you created during the initial configuration of your appliance.
4.
Type
show disk all
.
The image below shows the slots that have disk drives installed and the slots in which disk
drives are not installed.
Содержание ProxySG SG900-10
