Bidet BB - 3500 Installation
1. Shut off the incoming hot water to the sink and the incoming water to the toilet both at their
respective wall valves and drain the toilet’s water tank by flushing it.
2. Disconnect the existing hose that connects the wall valve to the toilet tank.
3. Connect the “Metal T-Connector” to the wall water supply valve,
remember to put the small
rubber washer inside the“Metal T-Connector” or the system will leak.
4. Reconnect the existing flexible hose, hand-tightening it to the “Metal T-Connector” and the
toilet tank. Tighten it but don't over do it.
5. Remove the hose or pipe that connects the hot water supply valve to the sink. This unit comes
with a larger 16” “Flexible Hose” that may later substitute the existing hose or pipe if needed.
6. Connect the “Brass T-Connector” to the hot water supply valve. (Noticing the conical tip on
the hot water Metal T-Connector can differentiate the two metal connectors).
