20mm Fountain
B20-ST-112
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Fountain (B20-ST-112)
Remove the two base pieces from the sprue.
Glue them together using the guidelines to align
then correctly.
Next remove the large solid disks and the support
post from the sprue..
Glue the support post to the base (you may find it
easier to glue a small piece of scrap to the
underide of the hole first.) and glue the discs to
the post as shown.
Remove the four rings from the sprue.
Glue these in a stack and attach them to the base.
