6mm Car park
B06-CS-006
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the base floor and four walls (as shown above)
from the sprue.
Glue the walls to the base as shown, using the
lugs/holes provided to align the sections.
Remove each set of “leg” pieces (pair on the left) from
the sprue and glue them together to form the piece on
the right.
Glue the legs to the underside of the upper storey’s
floor (as shown).
Each end of the supper storey is formed from the
pieces shown.
Glue the inner piece into place.
Then add the small wall and ramp.
Then the outer wall.
