10mm Skyscraper Dice Tower
B10-CS-023
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the pieces shown above from the sprue.
Attach the ramps to one of the side pieces (see pic)
Then glue the other side piece into position.
Take the two end strips.
Glue these into place.
The inner bracing supports.
