P a g i n a
|
5
MANUAL
|
yooBee Wrist Tracker yB-010050-WT
3.
Using the device
In operational mode, the tracker is active and connected to at least one and up to three yooBee
Hubs. It periodically broadcasts data from its inertial sensors, which is used in the Cloud
Console to track the position of the device.
If no movement was detected in the last 15 sec, the tracker goes into a sleep mode to preserve
battery life time. It is re-activated as soon as movement is detected.
In the background, the device runs protocols to establish and maintain connection with yooBee
Hubs in its proximity, and to roam between them.
The yooBee Wrist Tracker has a multi-colored LED, that is used to provide feedback in case of
a call-for-assistance:
LED Code
Meaning
Series of short blue blink
Firmware update
1x red after firmware update blue blinks
Firmware update failed
Red - blinking
Attempt to send button event
Green
Button event sent and acknowledged
4.
Troubleshooting
In case of possible malfunction, please contact technical support to receive proper
replacements (email: [email protected]). Replacement policy also applies to performance
faults caused by low battery before prescribed operation time.
5.
Disposal of the device
yooBee Wrist Trackers contain electronic elements and batteries which should be properly
disposed and compliant to local regulations.
6.
Safety Instructions
Opening yooBee Wrist Trackers is strictly forbidden. Switching the original battery with one of
a different type might cause a risk of explosion.
