25 / 63 EN
Over The Range Convection Microwave Oven / Installation Manual
5
Installation
B5. Adapting microwave blower for
outside back exhaust
1. Remove and save screw that holds blower
motor to microwave.
Back of
Microwave
Blower Motor
Blower Motor
Screw
2. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
End B
End A
Forward
Openings Facing
Before: Fan Blade
3. Roll the blower unit 90°
Back of
Microwave
Back of
Microwave
Before Rotation
After Rotation
4. Rotate blower unit counterclockwise 180°.
Before Rotation
After Rotation
Back of
Microwave
Back of
Microwave
5. Gently remove the wires from the grooves.
Reroute the wires through grooves on other
side of the blower unit.
Before Rerouting
After Rerouting
Wires Routed Through Right Side
Wires Routed Through Left Side
6. Roll the blower unit 90° so that fan blade
openings are facing out the back of the
microwave.
Before Rolling
After Rolling
Back of
Microwave
Back of
Microwave
7. Remove the knockout plates in the back of the
unit with snips.
Back of mircrowave
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear airflow.
Please take care to
remove any sharp edges
created from removing
the knockout plates.
