Blohm + Voss Oil Tools FloorHand 9GF-1102, Техническая документация инструкция

Страница: 50 / 105

50
MAI
N
TE
N
AN
C
E
&
IN
SP
EC
TI
O
N
Grease Quality
In order to achieve efficient lubrication even
at different environmental temperatures, we
recommend that the following grease types
be used:
Multipurpose grease, e.g.:
Shell Alvania RL 3
Aviaticon XRF NLGI 0
Alternatively; use EP gear lubricating grease for greasing ”non-oil tight gear trains”
NESSOS SF0
NLGI 0
DIN 51 826 GPOF-25
DIN 51 502 GPOF-25
For environments in the range of 65 to 95 degrees Fahrenheit or 18 to 35 degrees Celsius,
we recommend using a mineral / based lubricant such as ISO 68 or equivalent.
Lubrication
The FloorHand should be inspected and greased each week. For higher ambient tempera-
ture up to 86° Fahrenheit (30° Celsius) we recommend to use NLGI grade 2. The grease
points are:
The grease points are:
1. Die Blocks - Actuate both lower wrench clamp and upper wrench clamp to expose the
grease fittings before turning off the hydraulic power unit. Use a grease gun on each of
the 4 fittings (Front and back) on each die block to lubricate the centering buttons.
2. Die Blocks - With the Die Blocks extended, brush grease on the top, bottom and sides of
each die block.
3. Spinner gears - Brush grease onto the drive gear teeth. Take care to keep grease off of
the drive rollers.
4. Torque cylinder pins - Use a grease gun on the fitting on the top of each torque cylinder
pin.
WARNING: AlWAys tuRN off the hydRAulIc poWeR
uNIt, dIscoNNect the hydRAulIc lINes ANd tAG out
the hpu coNtRol befoRe lubRIcAtING the flooRhAN..
fAIluRe to do so mAy cAuse INjuRy to peRsoNNel oR
dAmAGe to the equIpmeNt.