Blizzard 57520-1, Руководство пользователя

Страница: 16 / 40

Lit. No. 40688, Rev. 04 16 May 1, 2012
MOUNTING SNOWPLOW (ON)
NOTE: Use dielectric grease to prevent corrosion
on all connections.
1. Slowly drive the vehicle forward to engage the
mount adapter into the A-frame.
2. Move the Power switch to the center, or "OFF,"
position.
3. Plug in electrical harnesses.
4. Push and hold the Power switch RIGHT, and push
UP and hold the Arm/Blade Operation switch. The
arm will engage the mount adapter and pull the
snowplow toward the vehicle.
MOUNTING SNOWPLOW TO VEHICLE
WARNING
Keep 8' clear of the blade when it is being
raised, lowered or angled. Do not stand
between the vehicle and blade or directly in
front of the blade. If the blade hits or drops on
you, you could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever mounting or
removing the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
5. Rotate and release the hitch pin. The hitch pin is
fully engaged when the pin handle is against the
pin guide plate.
6. Repeat Step 5 on the passenger's side.
7. While holding the Power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch.
The arm will disengage the mount adapter to
relieve tension on the stand.
8. Pull the stand handle up. The stand will lift off the
ground. Pull the stand pin out. Rotate the stand up
until the stand pin seats into the upper hole on the
A-frame. The pin must lock into the upper A-frame
hole.
9. Repeat Step 8 on the passenger's side.
10. Move the Power switch to the left, or "PLOWING,"
position.
Light
Tower
Power
Switch
Arm/Blade Operation
Switch
Switch
Label
ARM/BLADE
OPERATION POWER
OFF
Raise
Lower
Plowi
n
g
A
rm/Bl
a d
e
Opera
ti o
n
OFF
48207
Power Switch
Arm/Blade
Operation Switch
Hitch Pin
Mount
Adapter
Arm
A-Frame
Stand
Upper Hole
Stand Pin
Stand Handle
Light Tower
Boot
Blade
Shoe
ON
Hitch
Pin
Pin
Handle
Mount
Adapter
Pin
Guide Plate