Blix Aveny, Инструкция по сборке, Страница: 10 / 12

10
Step 7 : Seat Adjustment
To adjust the seat height, open the quick
release seat post clamp. Once you’ve
reached your desired height, simply
clamp the quick release back down so
it squarely closes against the collar. If
the seat height continues to slip when
pressure is applied, you can tighten the
nut on the quick release clamp by hand.
To adjust the
height of the stem
, loosen the stem
bolt. Ensure the stem is fully aligned to the front
wheel before tightening the bolt back down.
To adjust the
angle of the stem
, loosen the bolt
at the bottom of the stem. Ensure the bolt is tight
once you’ve reached your desired angle.
To adjust the
angle of the handlebar
, loosen the
handlebar clamp. Ensure both bolts are tight once
you have reached your desired wrist angle.
There are three adjustments you can make to the handlebar
position: height, stem angle, and wrist-angle. After adjusting
the handlebars, you should be able to sit up straight without
needing to hold your arms or wrists in an uncomfortable
position.
Step 8 : Handlebar Adjustment
Tip
:
You should be able to comfortably touch the
ground with your toes, and should be able to fully
extend your legs while pedaling. This is the optimal
height for your seat, but choose the height that
works best for you.
Follow the steps below to personalize your Aveny and
to check for safety.
Adjustment