Assembly Guide
Aveny Low-Step
®
Assembly video available
at support.blixbike.com
View on phone or desktop!
Step 6:
Install the seat. Insert the seat post. Adjust the seat post to the
desired height, and firmly tighten the quick release seat post clamp so
that it squarely closes against the collar.
Step 7:
Install the pedals. They are marked with an
“L” for the pedal to install on the left side of the bike
and marked “R” for the right side (side with chain and
gears).
Tighten the pedals securely by turning the pedals
towards the front of the bike with a wrench as seen
in the assembly video at support.blixbike.com. Install
carefully to not damage the thread.
Step 8:
Fully adjust the height and angle of the
handlebar and ensure all hardware is properly
secured as shown in the Aveny assembly video
at support.blixbike.com.
1. Loosen the bolt on the stem and adjust to
desired height. Make sure to fully align the
handlebar stem with the front wheel. Tighten
the bolt firmly so that the stem does not shift in
position. (8.1)
2. Adjust the angle of the handlebar stem to
desired position using the bolt below the
handlebar stem, then tighten. (8.2)
3. Loosen the bolt on the handlebar to rotate the
handlebar in the stem to find your desired
wrist angle. Securely fasten the bolt to lock
into position. (8.3)
Step 9:
Inflate the tires to the recommended
pressure 40-65 PSI, indicated on the tire sidewall.
Step 10:
Check brakes and that all bolts are tight before riding.
Recommended Torque Values
Tighten bolts to torque specifications to prevent the bolts from slipping.
Do not extend any components including the stem or
seat post beyond the minimum insertion markings,
which are etched into the seat post and stem. Before
using the bike, check that the saddle post quick release
bolt is closed and firmly tightened. Secure all hardware
properly or it may become loose and result in serious
injuries.
8.1
8.2
8.3
