Blitz GH Series, Инструкция по эксплуатации и список запасных частей

Страница: 9 / 44

Operating Instructions for Suspended Jacks
9
4.2 Install and assemble Jack
WARNING
Risk of injury and material damage by crashing jacks
 Install jack only on level and solid ground, which has the necessary load-bearing capacity.
 Use jack only on load-bearing and parallel rails.
Safety notes
 Use jack only with castors that fit the rails.
 Only use the jack in the workshop pit or lift for which it was made.

If the distance between the rails of vehicle lifts (e.g. scissor lifts) changes due to alternating load,
additional fuses need to be requested from the manufacturer.
There are five types of undercarriages:
• Undercarriages with sliding axles (adjustable)
•
Undercarriages with telescopic carriers (adjustable)
•
Single-piece undercarriages (rigid)
• Two-piece undercarriages (rigid)
• Transverse and height-adjustable undercarriages
Undercarriages with sliding axles
Standard castors
A
B
C

Insert undercarriage in rails.

Pull out sliding axes B evenly and set the track width.
 Tighten set threaded pins C.
 Check the secure support of the castors (standard castors min. 25 mm) over the entire length of
the rails.

Adjust enclosed clamping collars A and attach externally to sliding axles B.

Dismantle the tilt protection bracket [1] on the lifting cylinder, insert the lifting cylinder into the
undercarriage and replace the tilt protection bracket on both sides.
