3-2. Use Philips screwdriver to release terminal screws.
3-3. Fold the wire end to pass through the conduit and insert them into the input hole.
3-4. Fix the copper wire on the corresponding terminal block. The wiring instruction is printed
in front of the terminal block (L1/L2/G).
3-5. Use the following torque to connect the wire terminal to the terminal block.
Screw
Torque
M4
16 kgf.cm
13.88 lb-in
3-6. The recommended terminal specifications are as following.
Figure 2-12 Input wiring
Terminal
Dimension(mm)
W
≤ 9.5
d2
4-6.4
1
2
Basic/Smart/Intelligent Charger-32A
Installation Manual Rev. 4.0
BlinkCharging.com • (888) 998.2546
©2021 Blink Charging Co. • NASDAQ: BLNK
