17
In these sensing test, the camera would take pictures once
motion captured. When you open the camera, the screen
shows the number of times triggered, you can review the
pictures on the screen.
(Note: The red light will blink only
when the motion is within the sensing area of the central
PIR sensor. The central sensor's sensing angle of view is
60°. Each of the side sensors has a 30° angle of view,
which is only used to pre-activate the camera and
accelerate the triggering speed, there is no RED light
blinking whatever each of the side sensors detects motions.)
The results of your testing will help you find the best
placement when mounting and aiming the camera
.
The height
away from the ground for placing the device should vary with
the animal size appropriately. In general, 3 to 6 feet is
preferred.
You can avoid potential false triggers due to temperature and
motion disturbances in front of the camera by not aiming it at
a heat source or nearby tree branches or brush (especially on
windy days).
Do NOT install the camera behind the glass window as that is
not possible to sense any motion. Avoid aiming the camera
toward glass objects.
9.3. STARTING
The camera supports two working mode “Motion Detection”
and “Time Lapse”, press
START
button to enter surveillance
mode.
(1) If you set the camera working mode as “Motion detection”
in the menu, the camera countdowns 30-second delay, and
then will be ready to go into standby (surveillance) and
capture. Any motion that is detected by it will trigger the
