How to Use Your WMS
Installation
C3050K
•
WIRELESS MANAGEMENT SYSTEM
•
OWNER’S MANUAL
BLAZER INTERNATIONAL COM
-
.
1-800-241-3808
Page 1 of 12
Patent Pending • Brevet en attente • Patente pendiente
© Copyright 2016
Tiger Accessory Group LLC
,
Long Grove IL 60047
,
www blazer-international com
.
.
This product is a professional, remote control, wire management system. The WMS is designed for
operating accessories (including lights, horns, warning beacons, etc.) typically used on work or
off-road vehicles (trucks, jeeps, ATV/UTV, boats, heavy equipment, farm equipment, etc.).
The unit works on 12V DC and provides output to two banks of wiring terminals (4 each/bank),
a total of eight terminals in all. Each bank is protected by an independent 30A fuse. The fuse
protecting the “BLUE” bank of terminals is located closest to those terminals and the fuse protecting
the “GREEN” bank is closest to the green bank of terminals. Depending upon intended use,
the electrical system may require a higher capacity alternator and/or a battery. Consult with a local
installer or upfitter for guidance on proper amperage for vehicle type and additional planned powered
accessories.
Please note that the remote control can be clipped onto a visor, or conveniently stored within the
vehicle for easy access. It uses a 12V, A23 size alkaline battery that is included with the kit. If the
remote control is lost or broken – it can be replaced and the new remote “paired” with the existing
WMS.
1. Please read these instructions carefully before installing this product. It is recommended to
consult a professional installer to prevent damage to vehicle and/or system.
2. Do not connect to 24V DC or higher voltage system, as this product is designed for a 12V DC
battery system. In case you have a larger than 12V DC system, check vehicle owner’s manual to
determine if a 12V DC output is available and how to connect in order to use it safely, otherwise,
the product will be damaged.
3. Find a suitable flat surface near the battery, clean the surface free of dirt and oil and then affix the
unit using provided adhesive strips and/or mounting holes.
4. Remove the two fuses of WMS unit from their holders and disconnect the vehicle battery.
5. Securely attach the positive (red) cable of the WMS unit to the positive terminal of the battery (or
battery cable) and the negative (black) cable of the WMS to the negative battery cable or chassis.
6. Attach the auxiliary lights/equipment following correct polarity on the terminals and not exceeding
the maximum amperage of the channels (amperage printed on WMS and corresponds to amperage
printed on the remote control for each bank of terminals). See
7. Reconnect battery cables.
8. Insert the two fuses back into their holders and snap the covers closed.
a. Remote includes a 12V (A23 alkaline) battery.
b. Recycle used battery as per local codes.
9. Test by pressing remote button and checking accessory operation.
FIG 1
